1 Scope
This Part of GB/T 20234 specifies definitions, requirements, test methods and inspection rules of charging connection assemblies for electric vehicles.
This part is applicable to the conductive charging connection assemblies for electric vehicles with
- rated AC voltage not exceeding 250A, 50 Hz, rated current not exceeding 250A;
- rated DC voltage not exceeding 1000V and rated current not exceeding 400A.
If the standardization plugs and socket-outlets according to GB 2099.1 are applied on the power coupler of the charging connection assemblies, this Part is not applicable to these plugs and socket-outlets.
Note: The vehicles in this Part refer to the externally connected charging electric automobiles.
2 Normative References
The following documents are indispensable for the application of this standard. For dated references, only the dated edition is applicable to this document. For undated references, the latest editions of the normative documents (including all the amendments) are applicable to this document.
GB 2099.1 Plugs And Socket-Outlets For Household And Similar Purposes - Part 1: General Requirements
GB/T 3956 Conductors Of Insulated Cables
GB 4208 Degrees Of Protection Provided By Enclosure(IP Code
GB/T 5013 Rubber Insulated Cables Of Rated Voltages Up To And Including 450/750 V
GB/T 5023 Polyvinyl Chloride Insulated Cables Of Rated Voltages Up To And Including 450/750V
GB/T 11918-2001 Plugs, Socket-Outlets And Couplers For Industrial Purposes--Part 1: General Requirements
GB/T 16916.1 Residual Current Operated Circuit-Breakers Without Integral Overcurrent Protection For Household And Similar Uses (RCCB)—Part 1: General Rules
GB/T 16917.1 Residual Current Operated Circuit-Breakers with Integral Over-Current Protection For Household And Similar Uses (RCBO)—Part 1: General Rules
GB/T 18487.1 Electric Vehicle Conductive Charging System--Part 1: General Requirements
GB/T 19596 Terminology of Electric Vehicles
3 Terms and Definitions
The terms and definitions specified in GB/T 19596, GB/T 18487.1 and GB/T 11918 -2001 and those specified in the following are applicable to this document.
3.1 Charging connectors
When the electric automobile is charged, the assemblies to connect electric automobile and electric automobile electrical equipment may possibly include the components such as power interface, vehicle interface, control box and capping sheet on the cable except the cables. The schematic diagram of charging connection assembly is seen in Figure 1.
Note: The charging mode and connection modes of the charging connection assembly this Part refers to are seen in Appendix A.
3.2 Charging coupler
In the charging connection assembly, power coupler and vehicle couplers are included except the components of cables and cable control box (if any).
Foreword I
1 Scope
2 Normative References
3 Terms and Definitions
4 Symbols And Abbreviations
5 Rated Value of The Charging Connection Device
6 Requirements
7 Test Methods
8 Inspection Rules
Appendix A (Informative) Electric Automobile Charging Mode And Connection Mode
