1 Scope
This standard specifies the technical requirements, test methods, test rules, mark, packaging and storage of the belt conveyer (hereafter referred to as “conveyer”).
This standard is applicable to the transportation of different kinds of massive, granular bulk materials as well as conveyers.
For conveyers with special requirements and patterns, the universal part shall also be referred to.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this national standard. For dated reference, subsequent amendments (excluding amending error in the text) to, or revisions of, any of these publications do not be applied. However, the parties whose enter into agreement according to these specifications are encouraged to research whether the latest editions of these references are applied or not. For undated references, the latest edition of the normative document is applicable to this national standard.
GB/T 191 Pictorial marking for handling of goods (GB 191-2008, ISO 780: 1997, MOD)
GB/T 528 Rubber, vulcanized or thermoplastic - Determination of tensile stress-strain properties (GB/T 528-1998, eqv ISO 37:1994)
GB/T 531 Rubber - Determination of indentation hardness by means of pocket hardness meters
GB/T 985 Basic forms and sizes of weld grooves for gas welding, manual arc welding and gas-shielded arc welding
GB/T 986 Basic forms and sizes of submerged arc weld grooves
GB/T 1184-1996 Geometrical Tolerancing - Geometrical tolerance for features without individual tolerance indications (eqv ISO 2768-2:1989)
GB/T 2828.1-2003 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection (ISO 2859-1:1999, IDT)
GB/T 3323-2005 Radiographic examination of fusion welded joints in metallic materials
GB/T 3512 Rubber, vulcanized or thermoplastic-Accelerated ageing and heat resistance tests-Air-oven method
GB/T 3767-1996 Acoustics - Determination of sound power levels of noise sources using sound pressure - Engineering method in an essentially free field over a reflecting plane(eqv ISO 3744:1994)
GB/T 4323 Pin coupling with elastic sleeve
GB/T 4490 Conveyor belts - Dimensions
GB/T 5014 Elastic pin coupling
GB/T 5015 Gear coupling with elastic pin
GB/T 5272 Coupling with elastic spider
GB/T 6402 Steel forgings - Method for ultrasonic examination
GB 7324-1994 General purpose lithium lubricating grease
GB/T 7984 Conveyor belts - Specification for rubber or plastics covered conveyor belts of textile constr ction for general use
GB/T 8923-1988 Rusting rating and derusting rating of steel surface before application (eqv ISO 8501-1:1988)
GB/T 9239.1-2006 Mechanical vibration - Balance quality requirements for rotors in a constant (rigid) state - Part 1: Specification and verification of balance tolerances
GB/T 9286-1998 Paints and varnishes - Cross cut test for films (eqv ISO 2409:1992)
GB/T 9770 Steel cord conveyor belts for general use
GB/T 9867 Rubber - Determination of abrasion resistance
Foreword II
1 Scope
2 Normative References
3 Basic Parameters
4 Technical Requirements
5 Test Methods
6 Test Rules
7 Mark, Packing and Storage
Appendix A
