1 Scope
This standard specifies the technical requirements, test methods, marking, etc. concerning the assembling of braking device of standard-gauge railway car.
It is applicable to new passenger car and wagon.
2 Normative References
The following standards contain provisions which, through reference in this standard, constitute provisions of this standard. At time of publication, the edition indicated was valid. All the standards will be revised and all parties coming to an agreement according to this standard are encouraged to investigate the possibility of applying the most recent editions of the standards listed below.
GB/T 3092-93 Welded Steel Pipe for Low Pressure Service
GB/T 7306-87 Pipe Threads where Pressure-tight Joints are Made on the Threads
GB/T 14976-1994 Stainless Steel Seamless Pipes for Fluid Transport
TB/T 1.1-95 Lettering and Marking of Railway Cars—General Regulations
TB/T 778-91 Technical Specification of Cast Iron Pipe Joint for Locomotive And Rolling Stock
TB 1492-83 The Method of Single Car for Railway Passenger Car and Wagon Brake
TB/T 1900-1998 General Technical Specifications for Wind Reservoir of Rolling Stock
TB/T 2401-93 The Method of Single Car for Railway Wagon Brake Equipped with Brake Shoe Slack Adjuster
TB/T 2424-93 Technical Specifications for Chained Hand Brake of Horizontal Wheels of Wagon
TB/T 2916-1998 General Technical Specifications for Two-direction Brake Shoe Slack Adjuster for Railway Vehicle
