SN/T 1688.5-2012 Rules for the inspection of power-driven vehicles for import and export - Part 5: Electric motorcycles and electric mopeds
1 Scope
This part of SN/T 1688 specifies the sampling, inspection, and result determination of electric motorcycles and electric mopeds for import and export.
This part is applicable to the inspection of two- and three-wheeled electric motorcycles and electric mopeds (hereinafter referred to as electric motorcycles, unless otherwise specified) for import and export.
This part is not applicable to the inspection of off-road vehicles and racing vehicles.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition (including any amendments) applies.
GB/T 2828.11-2008 Sampling procedures for inspection by attributes - Part 11: Procedures for assessment of declared quality levels for small population
GB/T 5359.1 Term for motorcycles and mopeds - Part 1: Types of vehicles
GB/T 5359.4 Term for motorcycles and mopeds - Part 4: Mass of vehicle with two and three wheels
GB/T 5382 Performance and measurement method for braking force of motorcycles and mopeds
GB 7258-2004 Safety specifications for power-driven vehicles operating on roads
GB 15365 Symbols for controls, indicators and tell tales for motorcycles and mopeds
GB/T 15367 Motorcycles and mopeds part and component - Designations for vehicle with two and three wheels
GB 24155-2009 Electric motorcycles and electric mopeds - Safety specifications
GB/T 24158-2009 General specifications for electric motorcycles and electric mopeds
QC/T 791 Electric motorcycles and electric mopeds - Engineering approval evaluation program
SN/T 0002 General stipulations for drafting of rules for inspection of import and export mechanical electrical commodity
3 Terms and definitions
For the purposes of this document, the terms and definitions given in GB/T 5359.1, GB/T 5359.4, GB/T 15367 and SN/T 0002 as well as the following apply.
3.1
mode of sampling inspection
qualification assessment activity of sampling, inspection and check of commodities for import and export lot by lot or in sampled lots in accordance with the mandatory requirements of national technical specifications
3.2
mode of type test
qualification assessment activity of carrying out type test according to the mandatory requirements of national technical specifications in the prescribed period, conducting sampled-lot inspection of products according to the on-site inspection regulations, and supervising the quality management system of enterprises
Foreword i
Introduction ii
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Inspection
6 Determination of acceptable lot and its validity period
7 Disposal of rejected lot
