1 Scope
This part of QC/T 29063 specifies the structural type, technical requirements, test conditions, inspection rules, marking, packaging, transportation, storage and quality guarantee of manual transmission assembly of light-duty automobile and mini-duty automobile .
This part is applicable to manual transmission assembly for passenger car and commercial car (hereinafter referred to as transmission) with an input torque not greater than 200N•m.
2 Normative references
The following referenced documents are indispensable for the application of of this document of QC/T 29063. For dated references, only the edition cited applies For undated reference, the latest edition (including any amendments) applies.
GB/T 12678 Reliability running test method for automobiles
QC/T 465 Automotive mechanical transmission terminology and definition
QC/T 568.1 Rig testing method for auto manual transmission assembly - Part 1: Mini-vehicle
QC/T 572 Rules for cleanliness of automobile - Determination method
QC/T 573 Rules for cleanliness of automobile - Personnel, articles and environment
QC/T 575 Work guide for automobile cleanness - Analysis method of impurity
Technical policy for the recovery of automobile products - No.9 Notice of the National Development and Reform Commission, the Ministry of Science and Technology and the Ministry of Ecology and Environment (2006)
3 Terms and definitions
For purpose of this part, the terms and definitions specified in QC/T 465 and those listed below apply.
Foreword i
Introduction iii
1 Scope
2 Normative references
3 Terms and definitions
4 Structural type
5 Technical requirements
6 Test methods
7 Inspection rules
8 Marking, packaging, transportation and storage
9 Quality guarantee
Annex A (Normative) Spontaneous out-of-gear test of transmission on road
