1 Subject Content and Application Scope
This standard specifies technical requirements and methods for cleaning, rust prevention and interior packaging of rolling bearing, rolling element (steel ball, roller and roller pin) and other bearing parts.
This standard is applicable to cleaning, rust prevention and interior packaging, inspection and acceptance of rolling bearing, steel ball, roller, roller pin and other bearing parts carried out by the manufacturer and the users.
2 Normative References
GB 253 Lamp Kerosene
GB 307.3 Rolling Bearings - General Technical Regulations
GB 1789 Cleansing Gasoline for Aviation
GB 1922 Solvent Naphtha
GB 4456 Polyethylene Blown Film for Packaging
GB 4879 Rustproof Packaging
GB 8597 Rolling Bearings - Packaging and Packing
GB/T 265 Petroleum Products - Determination of Kinematic Viscosity and Calculation of Dynamic Viscosity
GB/T 267 Petroleum Products - Determination of Flash and Fire Points - Open Cup
GB/T 361 Rust Preventing Oils and Greases - Test Method of Wet Heat
GB/T 511 Petroleum Products and Additives - Method for Determination of Mechanical Admixtures (Gravimetric Method)
SH/T 0080 Rust Preventive Oil and Grease - Corrosivity Test Method
SH/T 0081 Rust Preventive Oil and Grease - Test Method of Salt Spray
SH/T 0195 Lubricating Oils - Test Method of Corrosiveness
SH/T 0212 Rust Preventive Oils and Greases - Test Method of Removability
SH/T 0311 Test Method of Artificial Sweat Replacement Performance of Displacing Type Rust Preventive Oil
SH/T 0367 Displacing Type Rust Preventive Oil
3 Classification of Rust Prevention Packaging
3.1 Small bearing: outside diameter φ is less than φ47mm.
3.2 Medium bearing: outside diameter φ is between 47mm and 190mm.
1 Subject Content and Application Scope
2 Normative References
3 Classification of Rust Prevention Packaging
4 Rust-proof Life
5 Technical Requirements
6 Test Methods of Rust Preventives
7 Transportation, Storage and Rust-proof Life
Additional Explanations:
