1 Scope
This standard specifies the tests, inspections and procedures for verifying the performance of cranes (including its operation parameters and its capability to lift rated loads) (see ISO 7363).
This standard is applicable to the types of cranes designated in ISO 4306-1, prior to first use following manufacture or after modification or repair of the load-bearing structure or a component of an individual crane.
Where rated loads are governed by stability, a test procedure and test load are specified that permit stability margins to be easily verified.
2 Normative References
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 4306-1, Cranes - Vocabulary - Part 1: General
ISO 7363, Cranes and Lifting Appliances - Technical Characteristics and Acceptance Documents
ISO 11629, Cranes - Measurement of the mass of a Crane and Its Components
ISO 13202, Cranes - Measurement of Velocity and Time Parameters
ISO 14518, Cranes - Requirements for Test Loads
3 Types of Test and Inspection Procedures
3.1 Three types of test and inspection procedures are to be used to accomplish the aims of this standard:
Contents
Foreword I
1 Scope
2 Normative References
3 Types of Test and Inspection Procedures
4 Test and Inspection Procedures
5 Test Conditions
6 Test Report
Appendix A (normative) Stability Test and Test Conditions for Mobile Cranes
Bibliography
GB/T 5905-2011 引用如下标准：
*ISO 4306-1, Cranes - Vocabulary - Part 1: General *ISO 7363, Cranes and Lifting Appliances - Technical Characteristics and Acceptance Documents *ISO 11629, Cranes - Measurement of the mass of a Crane and Its Components *ISO 13202, Cranes - Measurement of Velocity and Time Parameters *ISO 14518, Cranes - Requirements for Test Loads
