1 Scope
This standard specifies the product classification and labeling, requirements, test methods, inspection rules as well as marking, packaging, transportation and storage of the reinforced and composite polymeric sheets for water proof (hereinafter referred to as "the sheets").
This standard is applicable to sheets made of polymer materials such as polyethylene and ethylene-vinyl acetate copolymer as the main materials and composite fabrics as the protection or reinforcement layer, and used for water proof and moisture proof of structures such as roof, indoor, wall, hydraulic and water conservancy facilities and underground engineering, as well as water proof of various green planting roof.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 528 Rubber, vulcanized or thermoplastic - Determination of tensile stress-strain properties
GB/T 529 Rubber vulcanized or thermoplastic - Determination of tear strength (Trouser, angle and crescent test pieces)
GB/T 1690 Rubber, vulcanized or thermoplastic - Determination of the effect of liquids
GB/T 3512 Rubber, vulcanized or thermoplastic - Accelerated ageing and heat resistance tests - Air-oven method
GB/T 6682 Water for analytical laboratory use - Specification and test methods
GB/T 9758.1-1988 Paints and varnishes - Determination of "soluble" metal content - Part 1: Determination of lead content - Flame atomic absorption spectrometric method and dithizone spectrophotometric method
GB/T 9758.4-1988 Paints and varnishes - Determination of "soluble" metal content - Part 4: Determination of cadmium content - Flame atomic absorption spectrometric method and polarographic method
GB/T 9758.6-1988 Paints and varnishes - Determination of "soluble" metal content - Part 6: Determination of total chromium content of the liquid portion of the paint - Flame atomic absorption spectrometric method
GB/T 9758.7-1988 Paints and varnishes - Determination of "soluble" metal content - Part 7: Determination of mercury content of the pigment portion of the paint and of the liquid portion of water-dilutable paints - Flameless atomic absorption spectrometric method
GB/T 16777-2008 Test methods for building waterproofing coatings
GB 18173.1 Polymer water-proof materials - Part 1: Water-proof sheet
GB 18583-2008 Indoor decorating and refurbishing materials - Limit of harmful substances of adhesives
GB/T 23445-2009 Polymer-modified cement compounds for waterproofing membrane
JC/T 1075 Root penetration resistance of waterproof sheets for green roof system
3 Product classification and labeling
3.1 Product classification
Sheets are classified into the following two categories according to the main materials:
a) polyethylene composite environment-friendly sheet with a type code of F-PE;
b) ethylene-vinyl acetate copolymer composite environment-friendly sheet with a type code of F-EVA.
3.2 Product marking
3.2.1 Labeling method
The product shall be labeled in the sequence below, and the labeling contents may be added as required:
Type code - specification (length × width × thickness) - standard No.
3.2.2 Labeling example
Polyethylene composite environment-friendly sheet with a length of 50m, a width of 1.2m and a thickness of 0.7mm is labeled as follows:
F-PE-50m×1.2m×0.7mm-GB/T 26518
Foreword i
1 Scope
2 Normative references
3 Product classification and labeling
4 Requirements
5 Test methods
6 Inspection rules
7 Marking, packaging, transportation and storage
Annex A (Normative) Test method of composite strength
Annex B (Normative) Test method for adhesiveness at shear state
