Limits and measurement methods of electromagnetic compatibility for 900/1800MHz TDMA digital cellular telecommunications system - Part 1: Mobile station and ancillary equipment
1 Scope
This Part of GB/T 22450 specifies the requirements for the electromagnetic compatibility (EMC) of mobile station and ancillary equipment of Phase 1 and Phase 2 GSM 900 MHz and DCS 1800 MHz digital cellular telecommunication systems that transmit and receive voice and/or data, including the measurement methods, frequency range, limits and performance criteria.
This Part is applicable to portable and vehicular mobile stations, also applicable to those mobile stations that are powered by AC power supply and used at fixed position as well as the data terminals of various GSM 900 MHz and DCS 1800 MHz digital cellular telecommunication systems.
2 Normative References
The following documents contain provisions which, through reference in this Part of GB/T 22450, constitute provisions of this Part. For dated reference, subsequent amendments to (excluding corrections to), or revisions of, any of these publications do not apply. However, parties to agreements based on this Part are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For any undated references, the latest edition of the document referred to applies.
Contents
Foreword III
1 Scope
2 Normative References
3 Terms, Definitions and Abbreviations
3.1 Terms and Definitions
3.2 Abbreviations
4 Test Conditions
4.1 Universal Test Conditions and Configuration
4.2 Test Arrangement
4.3 Test-free Frequency Band
4.4 Measurement Conditions for Spurious Emissions
4.5 Measurement Conditions and Arrangement for Continuous Emissions
4.6 Immunity Test Conditions and Arrangement
4.7 Narrow-band Response of Receiver and Transceiver
5 Performance Criteria
5.1 Performance Evaluation Method
5.2 Performance Criteria for Transmitter under Continuous Emissions
5.3 Performance Criteria for Transmitter under Transient Emissions
5.4 Performance Criteria for Receiver under Continuous Emissions
5.5 Performance Criteria for Receiver under Transient Emissions
5.6 Performance Criteria under Discontinuity Condition
6 Applicability
6.1 Measurement of Emissions (See Table 2)
6.2 Immunity Test (See Table 3)
7 Measurement Methods and Limits for Emissions
7.1 Total Radiant Power
7.2 Conducted Spurious Emissions
7.3 Radiated Spurious Emissions
7.4 Enclosure Port of Ancillary Equipment
7.5 Telecommunication Port
7.6 Input/Output Ports of DC Power Supply
7.7 Input/Output Ports of AC Power Supply
7.8 Harmonic Current (Input Port of AC Power Supply)
7.9 Voltage Fluctuation and Flicker (Input Port of AC Power Supply)
7.10 Transient Conducted Emissions (Input/Output Ports of DC Power Supply)
8 Immunity Test Methods and Grades
8.1 Electrostatic Discharge Immunity Test
8.2 Radiated Emission Immunity Test
8.3 Electrical Fast Transient/Burst Immunity Test
8.4 Surge Immunity Test
8.5 Immunity Test of Conducted Emissions Induced by Radio-frequency Fields
8.6 Immunity Test of Voltage Dips, Short Interruptions and Voltage Variation
8.7 Transient and Surge Immunity Test (Vehicular Environment)
8.8 Power Frequency Magnetic Field Immunity Test
