1 Scope
This standard specifies the test method for CSIM application of terminal card interface for CDMA digital cellular mobile communication network, including test methods and judgment standards for CSIM application protocol, security and application, etc.
It is applicable to R-UIM CDMA terminal supporting CSIM application for CDMA digital cellular mobile communication network.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding corrections), or revisions, of any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
YD/T1168CDMA Technical Requirement of Subscriber Identify Module (UIM) for 800MHz CDMA Digital Cellular Mobile Telecommunication Network
YD/T 1683-2007 Testing Methods for CDMA Digital Cellular Mobile Communication Network ME-UIM Card Interface
YD/T 1763.1-2011 TD-SCDMA/WCDMA Digital Cellular Mobile Communication Network Test methods for USIM-ME (Cu) Interface Part 1: Physical, Electrical and Logical Characteristics
YD/T 1763.2-2011 TD-SCDMA/WCDMA Digital Cellular Mobile Communication Network - Test Methods for USIM-ME (Cu) Interface - Part 2: Application Characteristics of USIM
YDC024-2006 General Test Specification of 800MHz CDMA 1X : Mobile Station Part 2: Protocol Conformance Test Part
3 Abbreviations
For the purposes of this standard, the following abbreviations apply.
4 ME Test Environment
Figure 1 shows the test environment for an ME (device under test), including a CDMA System Simulator (CSS).
Foreword i
1 Scope
2 Normative References
3 Abbreviations
4 ME Test Environment
4.1 Definition of Default Values for ME-CSIM Card Interface Test
4.2 CSIM file Definition with FDN Function
4.3 Definition of Initial Conditions
5 ME Card Interface Physical and Electrical Logic Characteristics Test (UICC)
6 ME Card Interface CSIM Application Test Program
6.1 ME Interaction, Initialization and Session Abortion
6.2 MS Identification
6.3 UIM_ID/ESN_ME Selection
6.4 Security-related Commands
6.5 Phone Program
6.6 OTASP/OTAPA Function
6.7 Processing of PIN
6.8 Fixed Dialing Number (FDN)
6.9 Abbreviated Dialing Number (ADN)
6.10 Detection of the Presence or Absence of USIM
6.11 Suggested Slot Cycle Index
6.12 Global Service Redirection between the Same Frequency Bands
6.13 Service Provider Name
6.14 Application Label
6.15 Equipment Module Information
6.16 Emergency Number
6.17 SMS Capability
6.18 SMS on CSIM
6.19 SMS Parameters On CSIM
6.20 SMS state on CSIM
6.21 Simple IP
6.22 Mobile IP
6.23 Data Configuration
6.24 HRPD Access Authentication
6.25 WAP Browser Connection Parameter
6.26 WAP Browser Bookmark
6.27 MMS Publisher Connection Parameters
6.28 MMS Configuration
6.29 MMS Notification
6.30 (MMS User Preferences)
6.31 Java
6.32 Root Certificate
