1 Scope
This standard specifies determination method of turbidity of water used in boil and cooling system.
This standard is applicable to analysis of turbidity of water used in boil and cooling system within the turbidity range of (4~400)FTU.
2 Normative References
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this Standard are encouraged to study whether the latest editions of these documents apply. For undated references, the latest editions apply.
GB/T 6903 Analysis of Water Used in Boil and Cooling System — General Rule
JIS K0101:1998 Determination of Turbidity
3 Principle
This standard is modified in relation to JIS K0101:1998. The rationale is that determination is made by comparing light transmission of measured water sample and standard suspension by spectrophotometer using formazine suspension as the standard.
The colored water sample can be filtered with a 0.15 μm membrane filter and used as the blank solution.
4 Reagents and Materials
4.1 Reagent purity shall comply with GB/T 6903.
4.2 Turbidity-free water: filter Class II reagent water with a 0.15 μm filter membrane at a flow rate of 3 mL/min, and discard 200 mL of the initial filtrate. It is prepared just before use.
Foreword i
1 Scope
2 Normative References
3 Principle
4 Reagents and Materials
5 Apparatus
6 Analytical Procedures
7 Test Report
