This regulation is applicable to the initial verification, subsequent verification, in-service inspection, type approval and prototype test of heat meters.
Verification of heat meters used to measure the absorbed heat quantity may refer to this regulation.
1 Scope 2 References 3 Terms and Definitions 3.1 Heat Meter 3.2 Sub-assemblies of A Heat Meter 3.3 Ruted Operating Conditions 3.4 Total Verification 3.5 Component Verification 4 General 4.1 Working Principle 4.2 Structure 4.3 Calculation Formulas of Heat Energy 5 Metrological Performance Requirements 5.1 Airtightness and Strength of Flow-rate Sensor 5.2 Accuracy Grade of Heat Meter 5.3 Error Limit of Heat Meter 5.4 Repeatability Er of Non-impeller Flow-rate Sensor 5.5 Lower Temperature Limit of Heat Meter 5.6 Maximum Pressure Drop of Flow-rate Sensor 6 General Technical Requirements 7 Control of Measuring Instruments 7.1 Verification Conditions 7.2 Verification Items 7.3 Verification Methods 7.4 Treatment of Verification Result 7.5 Verification Cycle Appendix A Type Approval and Prototype Test Appendix B Enthalpy Value and Density of Water Appendix C Thermal Coefficient Table
