1 Scope of Application
The Rules is applicable to certification of low-carbon products concerning aluminum alloy architectural profiles, not aluminium alloy industrial profiles.
2 Certification Mode
Initial on-site verification + follow-up inspection after certification
3 Certification Application
Either product manufacturer or seller can entrust certification body to certify low-carbon products concerning aluminum alloy architectural profiles.
3.1 Certification Unit Division
Product certification units are such divided based on untreated profiles, anodized profiles, electrophoretic coating profiles, powder coating profiles, fluorocarbon coating profiles and thermal barrier profiles; those with the same product classification are classified as the same certification unit. The same products manufactured by the same manufacturer but at different manufacturing and processing workshops are regarded as different units. Low-carbon product certification is performed separately for each individual unit.
3.2 Conditions for Application Processing
(1) Certification client, product manufacturer and manufactory have obtained corporate capacity registered by national industrial and commercial administrative department or the departments concerned;
(2) Manufactory has established and implemented quality and energy management system or regime;
(3) Manufactory has established low-carbon product management system and then implemented successfully for 6 months;
(4) Manufactory has obtained legal administrative license as required by regulations (if any), like production licence and other related licences;
1 Scope of Application 1
2 Certification Mode 1
3 Certification Application 1
3.1 Certification Unit Division 1
3.2 Conditions for Application Processing 1
3.3 Application Documents 1
4 Document Review 2
4.1 Purpose 2
4.2 Contents 2
4.3 Result 2
5 Preparation before Verification 3
6 Initial On-site Verification 3
6.1 Factory Quality Assurance Capacity Requirements for Low Carbon Certification of Aluminium Alloy Architectural Profiles 3
6.2 Consistency Inspection 4
6.3 Verification of Carbon Emissions within Calculation Range 4
6.4 On-site Verification Time 5
6.5 Initial On-site Verification Conclusion 5
7 Verification Report 5
8 Certification Results Evaluation and Approval 6
9 Certification Termination 6
10 Follow-up Inspection after Certification 6
10.1 Time 6
10.2 Contents 7
10.3 Conclusion 7
10.4 Results Evaluation 7
11 Re-certification 7
12 Certificate 7
12.1 Certification Certificate Maintaining 7
12.2 Alteration of Certified Product 7
12.3 Suspension, Resumption, Cancellation and Revocation of Certificate 8
12.4 Contents of Certificate and Accessories 8
13 Application of Certification Mark 8
13.1 Allowable Mark Pattern 9
13.2 Application of Mark 9
14 Charging 9
