1 Scope
This part specifies the test method of compatibility test between user equipment (UE) of 2GHz TD-SCDMA digital cellular mobile communication network and network equipment.
It is applicable to the compatibility test between UE of 2GHz TD-SCDMA digital cellular mobile communication network and network equipment.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this part. For dated references, subsequent amendments to (excluding corrections), or revisions, of any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest editions apply to this part.
YD/T 1367-2008 Technical Requirements for User Equipment of 2GHz TD-SCDMA Digital Cellular Mobile Communication Network
3 Abbreviations
For the purpose of this part, the following abbreviations apply.
ACLR Adjacent Channel Leakage power Ratio
ACS Adjacent Channel Selectivity
AFC Automatic Frequency Control
AGC Automatic Gain Control
AM Acknowledged Mode
AMR Adaptive Multi Rate
ANR Ambient Noise Rejection
AS Access Stratum
ASD Acceleration Spectral Density
ATM Asynchronous Transfer Mode
AuC Authentication Centre
AWGN Additive White Gaussian Noise
BCCH Broadcast Control Channel
BCH Broadcast Channel
BER Bit Error Ratio
BLER Block Error Ratio
CCCH Common Control Channel
CCPCH Common Control Physical Channel
CM Connection Management
CN Core Network
CRNC Controlling Radio Network Controller
CS Circuit Switched
CW Continuous Wave (un-modulated signal)
DAI Digital Acoustic Interface
DL Downlink
DPCH Dedicated Physical Channel
DPCH_Ec Average energy per PN chip for DPCH.
DRNC Drift Radio Network Controller
DTX Discontinuous Transmission
EIRP Effective Isotropic Radiated Power
Ec Average energy per PN chip
ERL Echo Route Loss
ERP Ear Reference Point
EVM Error Vector Magnitude
FACH Forward Access Channel
FDD Frequency Division Duplex
FER Frame Erasure Rate, Frame Error Rate
FPLMN Forbidden Public Land Mobile Network
Fuw Frequency of unwanted signal.
GMM GPRS Mobility Management
GPRS General Packet Radio Service
GSM Global System for Mobile Communications
HPLMN Home Public Land Mobile Network
IMEI International Mobile Equipment Identifier
IMSI International Mobile Subscriber Identity
MAC Medium Access Control
ME Mobile Equipment
MM Mobility Management
MRP Mouth Reference Point
MSC Mobile Switching Centre
NAS Non Access Stratum
OCNS Orthogonal Channel Noise Simulator
OPLMN Operator controlled PLMN
P-TMSI Packet TMSI
PDCP Packet Data Convergence Protocol
PDP Packet Data Protocol
PLMN Public Land Mobile Network
PPM Parts Per million
RAT Radio Access Technology
RF Radio Frequency
RLC Radio Link Control
RLR Receiving Loudness Rating
RPLMN Last Registered PLMN
SAR Specific Absorption Rate
SCCPCH Secondary Common Control Physical Channel
SIR Signal to Interference Ratio
SLR Sending Loudness Rating
SRNC Serving Radio Network Controller
SS Simulator System
STMR Sidetone Masking Rating
TDD Time Division Duplex
TFC Transport Format Combination
TMSI Temporary Mobile Subscriber Identity
UE User Equipment
UICC Universal Integrated Circuit Card
UTRAN Universal Terrestrial Radio Access Network
UPLMN User controlled PLMN
VPLMN Visitor PLMN
4 General
4.1 Test environment
In this part, the test environment can be divided into two types: commercial network test environment and laboratory test environment. The test content shall be carried out in the commercial network environment as much as possible. Considering the operational security of the commercial network, some test items, such as the test items requiring network parameter adjustment and special configuration, can be performed in the test network environment. And reference test environment is shown as in Table 1.
Foreword i
1 Scope
2 Normative References
3 Abbreviations
4 General
5 System Access
6 Location Area Update
7 Routing Area Update
8 Cell Reselection in Circuit Domain Idle Mode
9 Cell Reselection in Packet Domain Idle Mode
10 Paging
11 Cell Update/URA Update
12 Handoff
13 Circuit Domain Service
14 Packet Domain Services
15 Supplementary Service
16 Value-added Services
17 Concurrent Service
18 Call Performance
Annex A (Normative) Test Environment Recommendations
Bibliography
