1 Scope
This standard specifies the classification, requirements, test methods, inspection rules as well as marking, packaging, transport, storage of polyolefine injecting packing bucket.
This standard is applicable to polyolefine injecting packing bucket made of polyolefine as main raw material by injection molding.
2 Normative references
The following documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to (excluding any corrigendum), or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the latest editions of the standards indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 2828.1-2003 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection (ISO 2859-1:1999, IDT)
GB 9687-1988 Hygienic standard for polyethylene products used as food containers and tablewares
GB 9688-1988 Hygienic standard for polypropyrene products used as food containers and tablewares
3 Classification
Classification according to the sealing performance of packing bucket:
——sealed;
——unsealed.
Foreword i
1 Scope
2 Normative references
3 Classification
4 Requirements
5 Test methods
6 Inspection rules
7 Marking, packaging, transportation and storage
