Floor drain
1 Scope
This standard specifies the terms and definitions, classification, materials, requirements, test methods, inspection rules, marking, packaging, transportation and storage of floor drains.
This standard is applicable to floor drains used in civil buildings.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 1176 Casting copper and copper alloys
GB/T2828.1 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
GB/T 2829 Sampling procedures and tables for periodic inspection by attributes (apply to inspection of process stability)
GB/T 5231 Designation and chemical composition of wrought copper and copper alloys
GB/T 5270-2005 Metallic coatings on metallic substrates - Electrodeposited and chemically deposited coatings - Review of methods available for testing adhesion
GB/T 6461-2002 Methods for corrosion testing of metallic and other inorganic coatings on metallic substrates - Rating of test specimens and manufactured articles subjected to corrosion tests
GB/T 8170-2008 Rules of rounding off for numerical values & expression and judgment of limiting values
GB/T 8801 Test method for unplasticized polyvinyl chloride (PVC-U) fittings by falling
GB/T 8802 Thermoplastics pipes and fitting - Determination of vicat softening temperature
GB/T 9286-1998 Paints and varnishes - Cross cut test for films
GB/T 10125-2012 Corrosion tests in artificial atmospheres - Salt spray tests
GB/T 20878 Stainless and heat-resisting steels - Designation and chemical composition
GB/T 21873 Rubber seals - Joint rings for water supply drainage and sewerage pipelines - Specification for materials
GB/T 26311 Rods and bars of recycling copper and copper alloys
GB/T 27572 Rubber seals - Joint rings for pipelines for hot-water supply up to 110℃ - Specification for the materials
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
3.1 floor drain
device that receives accumulated water on the ground and transmits it to a drainage system
3.2 floor drain with seal
floor drain that only relies on water filling to form a trap seal inside to achieve sealing function
3.3 mechanical seal floor drain
floor drain that only relies on mechanical structure to achieve sealing function
3.4 blend seal floor drain
floor drain sealed by two or more methods
3.5 straight floor drain
floor drain without any structure preventing the gas in the drainage pipeline from spilling back
3.6 manual floor drain
floor drain with sealing cover, which is manually opened when draining and manually closed when no drainage required
3.7 side-drain floor drain
floor drain installed vertically and with the function of laterally receiving and discharging the accumulated water on the ground
3.8 floor drain with filter
floor drain with frame that can intercept sundries and be taken out for cleaning
3.9 spill-proof floor drain
floor drain with the function of preventing the waste water from spilling over the ground during discharge and preventing the waste water in the drainage system from spilling back to the ground
3.10 multi-channel floor drain
floor drain with multiple water inlet channels, which can receive both ground drainage and drainage of multiple appliances
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Materials
6 Requirements
7 Test methods
8 Inspection rules
9 Marking, packaging, transportation and storage
Annex A (Informative) Schematic diagram for basic structure of floor drain
Annex B (Normative) Floor drain inspection and test apparatus
