1 Scope
This Standard specifies the boundary dimensions, tolerances and definitions for sleeve type linear motion ball bearings.
This Standard is applicable to the size ranges covered by Table 1.
2 Normative References
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the reference document (including any amendments) applies.
ISO 1132-1 Rolling Bearings — Tolerances — Part 1: Terms and Definitions
ISO 5593 Rolling Bearings — Vocabulary
ISO 13012 Rolling Bearings — Linear Motion, Recirculating Ball, Sleeve type — Accessories
ISO 15241 Rolling Bearings — Symbols for Quantities
3 Terms and Definitions
Contents
Foreword I
Introduction III
1 Scope
2 Normative References
3 Terms and Definitions
4 Symbols
5 Boundary Dimensions
6 Tolerances
Appendix A
Bibliography
GB/T 16940-2012 引用如下标准：
* ISO 1132-1 Rolling Bearings - Tolerances - Part 1: Terms and Definitions * ISO 5593 Rolling Bearings - Vocabulary * ISO 13012 Rolling Bearings - Linear Motion, Recirculating Ball, Sleeve type - Accessories * ISO 15241 Rolling Bearings - Symbols for Quantities
