1 Scope
This standard specifies a method for the determination of the moisture content of a lot of iron ore.
This method is applicable to all iron ores, whether natural or processed.
2 Normative References
The following standards contain provisions which, through reference in this standard, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below.
GB/T 10322.1-2000 “Iron Ores - Sampling and Sample Preparation Procedures”
ISO 11323:1996 “Iron Ores – Vocabulary”
Note: The translation of ISO 11323:1996 is detailed in “Compilation of International Standard on Iron Ores” published in 1999 by the China Metallurgical Information Standardization Institute.
3 Definitions
For the purposes of this standard, the definitions given in ISO 11323 apply.
4 Principle
Foreword I
ISO Foreword II
Introduction III
1 Scope
2 Normative References
3 Definitions
4 Principle
5 Apparatus
6 Samples
7 Procedure
8 Verification
9 Calculation and Expression of Results
10 Test Report
Annex A (Normative) Determination of Moisture Content of Adhesive or Wet Iron Ores
Annex B (Normative) Corrections for Sprinkled Water and/or Rain-water
Annex C (Informative) Precision of Moisture Measurement
Annex D (Informative) Examples of Test Reports
