1 Scope
This standard specifies the type, main technical parameters, technical requirements, testing methods, inspection rules, marking, packaging, transportation and storage of sectional warping machine.
This standard is applicable to sectional warping machine used for the warping of cotton, wool, linen, silk, chemical fibre and blended yarn.
2 Normative References
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB 5226.1 Safety of Machinery - Electrical Equipment of Machines - Part 1: General Requirements
GB/T 7111.6 Textile Machinery - Noise Test Code - Part 6: Fabric Manufacturing Machinery
GB/T 8461 Textile Machinery and Accessories - Cone Sectional Warping Machines - Maximum Usable Width
GB/T 9239.1-2006 Mechanical Vibration - Balance Quality Requirements for Rotors in a Constant (Rigid) State - Part 1: Specification and Verification of Balance Tolerances
GB/T 17780 Safety Requirements for Textile Machinery
GB/T 20034 Textile Machinery and Accessories - Warp Creels - Main Dimensions
FZ/T 90001 Product Package of Textile Machinery
FZ/T 90035 Textile Machinery - Warper Beam Terms and Main Dimension
FZ/T 90074 Painting for The Products of Textile Machinery
FZ/T 90089.1 Type, Size and Technical Requirements for Textile Machinery Nameplate
FZ/T 90089.2 Content of Textile Machinery Nameplate
3 Product Types and Main Technical Parameters
3.1 Types
3.1.1 Main engine type: moving drum and its cone taper is determined according to the request of fabric.
3.1.2 Beaming type : fixed and movable types.
3.1.3 Bobbin creel type: rectangular frame, V-shaped frame, rectangular-V-shaped complex frame.
3.2 Main technical parameters
3.2.1 Speeds of warping and beaming are less than or equal to 1 000m/min and 200m/min respectively and are both classless and adjustable.
3.2.2 Maximum effective width of sectional warping machine shall meet the requirements of GB/T 8461.
3.2.3 Drum diameter: 500mm, 800mm, 1 000mm.
3.2.4 Maximum diameter adapting to the side disk of beam: 1 250mm.
3.2.5 Main dimensions of warping beam shall meet the requirements of FZ/T 90035.
3.2.6 Main dimensions of bobbin creel shall meet the requirements of GB/T 20034.
Foreword i
1 Scope
2 Normative References
3 Product Types and Main Technical Parameters
4 Technical Requirements
5 Test Methods
6 Inspection Rules
7 Marking, Packaging, Transportation and Storage
