1 Scope
This part under SN/T 1795 specifies requirements, inspection and judgment of <90t tyred and crawler-type hydraulic excavator (hereinafter referred to as used excavator) and may also be used as a reference for used excavators of other specifications, used hydraulic excavators with bulldozing function, used hydraulic chiselling machine and used hydraulic log loader.
Used excavators in this part are excavators that are under one of the following situations:
―Still possess basic function and certain use value after being used;
―Not being used but stored for a overlong time thus exceed quality assurance date or with obvious physical deprecition on parts;
―Assembled with new parts and used parts;
―After being repaired or renovated.
2 Normative Reference
The following normative documents contain provisions which, through reference in this part of SN/T 1795, constitute provisions of this part. For dated reference, subsequent amendments to, or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this part are encouraged to study whether the latest editions of these documents are applicable. For undated references, the latest edition of the normative document referred to applies.
GB/T 2828.1 Sampling Procedures for Inspection by Attributea-Part1: Sampling Schemes Indexed by Acceptance Quality Limit (AQL) for Lot-by-Lot Inspection (GB/T 2828.1-2003, ISO 2859-1: 1999, IDT)
GB 5226.1-2002 Safety of Machinery-Electrical Equipment of Machines-Part 1: General Requirements (idt IEC 60204-1: 2000)
GB/T 7586 Testing Method of Hydraulic Excavators
GB/T 9139.1 Hydraulic Excavators Classification
GB/T 9139.2 Hydraulic Excavators-Technical Specifications
GB 16710.1-1996 Earth-moving Machinery-Noise Limits
JB 6028 Construction Machinery-Safety Signs and Hazard Pictorials-General Principles
JB 6030-2001 Construction Machinery-General Safety Technical Requirements
3 Terms and Definitions
Terms and definitions established in GB/T 2828.1, GB 5226.1, GB/T 9139.1, GB/T 9139.2, GB/T 7586, GB/T 16710.1, JB 6030, JB 6028 and SN/T 0002 and those below are applicable to this part of SN/T 1795.
3.1 One hundred percent inspection mode
A qualification assessment for import and export commodity being subject to 100% inspection and checking according to compulsory requirements of national technical specification.
3.2 Documentation for filing of imported used electrical and mechanical products
A written determination issued by General Administration of Quality Supervision, Inspection and Quarantine (AQSIQ) or Inspection And Quarantine Bureau directly under AQSIQ for allowing administrative approval after examination for the filing application of consignee or other proxies of used electrical and mechanical products for import.
4 General Requirements
General requirements for inspection of used excavator include:
—Consistency requirements: consistent with the relevant national requirements, filing documentation of used electrical and mechanical products for import and the technical documents;
—Requirements like safety, hygiene and environmental protection: correspond with requirements of GB 5226.1-2005, GB 16710.1-1996 and JB 6030-2001.
Foreword I
Introduction II
1 Scope
2 Normative Reference
3 Terms and Definitions
4 General Requirements
5 Inspection
6 Result Judgment
7 Disposition of Unqualified Items
Appendix A (Informative) Laws and Administrative Regulations and Department Regulations Followed by Inspection of Used Excavators for Import
