QC/T 810-2009 Solenoid switch for automobile starters specification
1 Scope
This standard specifies the requirements, test methods, inspection rules, as well as marking, packaging, transportation and storage of solenoid switch for automobile starters.
This standard is applicable to the solenoid switch for automobile starters (hereinafter referred to as solenoid switch).
2 Normative references
The following documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to (excluding corrigendum), or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards. For undated references, the latest edition applies.
QC/T 413-2002 Basic specifications for automotive electrical equipment
QC/T 731-2005 Automotive starting motor specification
GB/T 4942.1-2006 Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification
GB/T 2828.1 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
3 Requirements
3.1 General requirements
The solenoid switch shall meet the requirements of this standard and shall be manufactured according to the drawings and technical documents approved through established procedure.
3.2 Materials
The materials for solenoid switch shall meet the corresponding material standards and customer requirements. All materials shall not contain asbestos or metal cadmium, and should not contain mercury, lead or hexavalent chromium.
Foreword i
1 Scope
2 Normative references
3 Requirements
4 Test methods
5 Inspection rules
6 Marking, packaging, transportation and storage
