1 Scope
This standard specifies technical requirements, test methods, inspection rules and marking, packaging, transportation and storage for motor driven windshield wipers of automobile.
This standard is applicable to motor driven wipers intended for use on automobile windshields.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding any corrigendum), or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For any undated references, the latest edition of the document referred to applies.
GB/T 10069.1-2006 Measurement of airborne noise emitted by rotating electrical machines and the noise limits—Part 1: Method for the measurement of airborne noise emitted by rotating electrical machines
JB/T 4159-1999 General technical requirements for electric products in the tropics
QC/T 46-1992 Type and size of electric windshield wiper for automobiles
QC/T 413-2002 Basic specification for automotive electrical equipment
QC/T 625-1999 Metallic coatings and conversion coatings for automobile
3 Terms and definitions
Foreword i
1 Scope
2 Normative references
3 Terms and definitions
4 Technical requirements
5 Test methods
6 Inspection rules
7 Marking, packaging, transportation and storage
