End-suction centrifugal pumps - Baseplate and installation dimensions
1 Scope
This standard specifies the baseplate and installation dimensions for end-suction centrifugal pumps (hereinafter referred to as pumps).
This standard is applicable to pumps and Y2 and Y3 series three-phase asynchronous motors.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 5662 End-suction centrifugal pumps (rating 1.6 MPa) - Designation, nominal duty point and dimensions
JB/T 8680 Specification for Y2 series (IP54) three-phase asynchronous motor (frame size 63~355)
JB/T 10447 Specification for Y3 series (IP55) three-phase induction motor (frame size 63~355)
3 Baseplate and installation dimensions
3.1 The dimensions of pumps shall meet the requirements of GB/T 5662. The installation dimensions of motors shall meet the requirements of JB/T 8680 and JB/T 10447.
3.2 the baseplate No. and dimensions are shown in the Table 1 and Figure 1. The basic installation dimensions are shown in Figure 2.
Foreword i
1 Scope
2 Normative references
3 Baseplate and installation dimensions
Bibliography
