Industrial trucks - Electromagnetic compatibility
1 Scope
This standard applies to industrial trucks regardless of the power source (called only trucks) as defined in ISO 5053, variable reach trucks and their electrical/electronic systems when used in residential, commercial, light industry and industrial environment (see EN 50081-1:1992 and GB/T 17799.2-2003).
This standard defines:
—— the requirements and the limit values for electromagnetic emission and immunity;
——the procedure and criteria for testing trucks and their electrical/electronic systems.
This standard does not cover:
——trucks intended for use outside the electromagnetic environments specified above;
——trucks intended for use on public highway with maximum speed exceeding 25 km/h;
——driverless industrial trucks and their systems;
——interaction between systems on the trucks;
——interference to on-board radio equipment;
——equipment connected to AC-mains which is only used when the truck is not being operated (e.g. on board charger)
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 17799.2-2003 Electromagnetic compatibility - Generic standards - Immunity for industrial environments (IEC 61000-6-2 : 1999, IDT)
EN 50081-1:1992 E1ectromagneticcompatibility - Generic emission standard - Part 1: Residential, commercial and light industry
EN 55022 Information Technology Equipment - Radio Disturbance Characteristics - Limits and methods of measurement
EN 61000-4-2 Electromagnetic compatibility(EMC) - Part 4 : Testing and measurement techniques—Section 2 : Electrostatic discharge immunity test—Basic EMC publication
EN 61000-4-3 Electromagnetic compatibility (EMC)—Part 4 : Testing and measurement techniques Section 3 : Radiated, radio—frequency, electromagnetic field immunity test
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
3.1
test sample
truck and/or electrical/electronic system for subjecting to type test according to this standard. This sample shall be able to represent similar versions of trucks and/or systems with the same design concepts, concerning:
Foreword I
Introduction II
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Tests
6 Information for use
Bibliography
