1 Scope
This part of GB/T 22719 specifies the test method for interturn insulation test of random-wound winding for AC electrical machines.
This part is applicable to the inspection of interturn insulation of random-wound winding for three-phase or single-phase AC electrical machine with rated voltage of 1140V and below.
2 Normative References
The following documents contain provisions which, through reference in this part of GB/T 22719, constitute provisions of this part. For dated references, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest editions apply to this part.
JB/T 9615.2-2000 Test limits of the interturn insulation on random-wound winding for AC low-voltage machines
3 Terms and Definitions
For the purposes of this part, the following terms and definitions apply.
3.1
comparison method of impulse waveforms
one method to conduct interturn insulation of electrical machine winding (or coil) through impulse voltage test.
the principle is to apply the impulse voltage wave with the specified peak and wave front time alternately (or simultaneously) directly to the tested winding and the reference winding (or coil) with the same design, and detect whether the interturn insulation of electrical machine winding (or coil) is good by judging whether there is a difference in the damped oscillation waveform caused by the impulse voltage. See Annex A.
3.2
reference winding (or coil)
the electrical machine winding (or coil) used to be compared with the tested winding (or coil) where the interturn insulation of electrical machine winding (or coil) is detected through comparison method of impulse waveforms.
Foreword i
1 Scope
2 Normative References
3 Terms and Definitions
4 Test Instruments
5 Test Methods
6 Selection Principle of Test Connection
7 Test Judgment
8 Automatic Test and Automatic Discrimination
Annex A (Informative) Impulse Waveform Comparison Method
