1 Scope
This standard specifies the classification, model, requirements, test methods, inspection and acceptance, and marking, painting, packaging and accompanying documents of municipal solid waste incinerator and boiler.
This standard is applicable to the design, manufacture, commissioning and acceptance of municipal solid waste incinerator and boiler that take municipal solid waste as fuel.
This standard may be referred to for the municipal solid waste incinerator and boiler mixed with non-hazardous wastes, and those mixed with conventional fuels or using conventional fuels to support combustion.
2 Normative references
The following documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments to (excluding corrections to), or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB 1576 Water quality for industrial boilers
GB/T 3766 Hydraulic fluid power - General rules relating to systems (GB/T 3766-2001, eqv ISO 4413: 1998)
GB/T 9222 Strength calculation of pressure parts for watertube boilers
GB/T 10180 Thermal performance test code for industrial boilers
GB/T 10184 Performance test code for utility boiler
GB/T 12145 Quality criterion of water and steam for generating unit and steam power equipment (GB/T 12145-1999, neq JIS B 8223: 1989)
GB/T 16508 Strength calculation of pressure parts for shell boilers (GB/T 16508-1996, neq ISO 5370: 1992)
GB/T 16618 General principles for thermal insulation technique of industrial furnaces
GB 50185 Standard for inspection and evaluation of thermal insulating work of industrial equipment and pipeline
GB 50264 Code for design of industrial equipment and pipeline insulation engineering
Foreword I
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Model
6 Requirements
7 Test methods
8 Inspection and acceptance
9 Marking, painting, packaging and accompanying documents
Annex A (Normative) Technical requirements for MSW grate incinerators
