1 Scope
This standard specifies the classification, requirements, test methods, inspection rules as well as marking, packaging, transportation and storage for domestic insulated containers.
This standard is applicable to domestic insulated containers composed of enclosure and double-glass vacuum inner container (hereinafter referred to as inner container) with coating on suction surface for storing drinking water and other foods.
2 Normative References
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. At the time of publication, all the editions indicated are valid. All standards are subject to revision, and parties to agreements based on this code are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below.
GB/T 2828-1987 Sampling Procedures and Tables for Lot-by-lot Inspection by Attributes (Apply to Inspection of Successive Lots or Batches)
GB/T 6388-1986 Transport Package Shipping Mark
GB/T 6543-1986 Corrugated Box
GB/T 6582-1997 Glass - Hydrolytic Resistance of Glass Grains at 98℃ - Method of Test and Classification (eqv ISO 719:1985)
HG/T 2885-1997 Pressure Sensitive Adhesive Polypropylene Tapes for packaging
QB/T 3724-1999 Inner Containers of the Vacuum Flask - Resistance to Vertical Load - Test Method
QB/T 3726-1999 Inner Containers of the Vacuum Flask - Heat Loss - Test Method
QB/T 3727-1999 Inner Containers of the Vacuum Flask - Thermal Shock - Test Method
QB/T 3826-1999 Corrosion-resistant Testing Method of the Metal Deposits and Conversion Coatings for the Light Industrial Products - Neutral Salt Spraying Test (NSS)
QB/T 3832-1999 Evaluation of the Corrosion Test Results of the Metal Deposits for the Light Industrial Products
3 Classification and Part Name
3.1 Classification
According to the type and nominal capacity of domestic insulated container, see Table 1.
Foreword i
1 Scope
2 Normative References
3 Classification and Part Name
4 Requirements
5 Test Methods
6 Inspection Rules
7 Marking, Packing, Transportation and Storage
Annex A (Normative) Inner Container
Annex B (Normative) Enclosure
